HomeAbout UsSports FieldsLandscape ContractorHome OwnerTurf TipsContact us905-263-2126

 

Proud Members Of:
Landscape Ontario TPI nsga RTF Sod Durham Construction CFIB
 



The following are Turfgrass Producers International (TPI) basic steps to a beautiful lawn.

Step One: Measuring and Ordering

With a tape, measure the area of your planned lawn in square feet. Include these measurements on a sketch of the lawn area, with the length, width, and any unusual features. We will be happy to determine the amount of turfgrass sod you will need from your sketch.

Click here to use the online calculator to determine the amount of Vissers Sod needed for your project. It's quick and easy!

Schedule your order for delivery of turf after preparatory work is completed and you are ready to install. Prompt installation on the day of delivery is crucial to a strong beginning for your lawn.

Step Two: Soil Preparation

For best result, rototill or spade the area to a depth of 10 to 15 cm. (4 to 6 in.). Eliminate drainage problems by having soil slope away from foundations, etc.

Then lightly rake in fertilizer starter. Rake and smooth the soil removing rocks, roots, and large clods. Roll the area lightly with a lawn roller 1/3 full of water. This will firm the soil surface and reveal low areas that need more soil. Keep the grade 2 to 3 cm. (1 in.) below sidewalks or driveway.

Step Three: Turf Installation


Install your lawn immediately upon delivery. Begin watering lawn within 30 minutes of installation. Turf is a living plant that requires ground contact and moisture to survive!

In hot weather, protect unlaid turf by placing stacks in shade.

Begin installing turf along the longest straight line, such as a driveway or sidewalk. Butt and push edges and ends against each other tightly, without stretching. Avoid gaps or overlaps. Stagger the joints in each row in a brick-like fashion, using a large sharp knife to trim corners, etc. On slopes, place the turf pieces across the slope.

To avoid causing indentations or air pockets avoid repeated walking or kneeling on the turf while it is being installed or just after watering.

After installing the turf, roll the entire area to improve turf/soil contact and remove air pockets.

Step Four: Watering


Give your new lawn at least 1 inch of water within 1/2 hour of installation. Water daily, or more often, keeping turf moist until it is firmly rooted (about 2 weeks). Then less frequent and deeper watering should begin. Generally we recommend watering every day the first week, every other day the second week and every third day the third week.

Weather conditions will dictate the amount and frequency of watering. Be certain that your new lawn has enough moisture to survive hot, dry, or windy periods. Water areas near buildings more often where reflected heat dries the turf.

 

 

       

       

       

       

       

       

       

© Copyright 2010 Vissers Nursery and Sod Farm        I Privacy Policy I